50ML pneumatic AB pusher, instead of traditional manual operation, is suitable for two-component glue drops 1:1 and 2:1, such as epoxy resin, silica gel and AB glue, etc. The dispensing is lighter, faster and more precise, which can effectively improve production efficiency, guarantee the quality of dispensing, reduce loss and save production cost!
1. 50ML pneumatic AB pusher is mainly used for quantitative dispensing of glue, and the whole glue is installed into the corresponding AB pusher for directly dispensing glue.
2. 50ML pneumatic AB pusher, available in the market with four specifications: 1:1, 2:1, 4:1, 10:1.
3. In place of traditional manual operation, dispensing is lighter, faster and more accurate, which can effectively improve production efficiency, guarantee the quality of dispensing, reduce loss and save production cost;
1. Directly put the glue into the AB pusher;
2. Connect the rubber pusher with the air pipe;
3. One end of the air pipe is connected with the air output interface of the controller;
4. Adjust the air pressure regulating valve and set proper air pressure;
5. Set the drip time;
6. Connect the foot switch and press the foot switch;
7. Start dripping glue;
